2GIG Wireless Thin Door/Window Contact (2GIG-DW10-345)- Brand New

Monitor the status of any open/close object, including a door, window, cabinet, drawer, etc., with the 2GIG Wireless Thin Door/Window Contact. The wireless, battery-powered sensor works with the 2GIG Go!Control panel or Vario wireless receiver, and features an exceptionally narrow width to fit into small spaces. When the monitored door/window is opened, the sensor signals the control panel to trigger an alarm.
Monitors open/close status of an object
Narrow 3/4″ sensor fits into small spaces
Supports internal and external contacts
Can be used for two security zones
Works with 2GIG wireless systems (345 MHz)
In addition to monitoring the primary door/window, the Thin Door/Window Contact can be used for a second security zone. It has an external input that accepts Normally Closed (NC) dry contact devices. The sensor also has a tamper-resistant cover that will trigger an alert if removed.
How It Works
The Door/Window Contact consists of two pieces (sensor and magnet), which easily install using the included mounting tape. The sensor mounts on the door/window itself, and the magnet mounts on the frame. When the two are separated, the sensor signals the control panel.
Contents
Door/Window Contact
Magnet
(2) Screws
Mounting Tape
Wire Lead, 12″
(2) Lithium Batteries
Instruction Manual
NOTE: Requires connection to a 2GIG wireless system, such as a GoControl Panel
Technical Details
Wireless Signal Range:
350 feet, open air, with 2GIG Wireless Control Panel
Code Outputs:
Alarm; Alarm Restore; Supervisory; Low Battery; External Alarm; External Restore; Tamper; Tamper Restore
Transmitter Frequency:
345.000 MHz (crystal controlled)
Transmitter Frequency Tolerance:
±15kHz
Transmitter Bandwidth:
24kHz
Modulation Type:
Amplitude Shift Keying-On/Off Keying (ASK-OOK)
Unique ID Codes:
Over one million different code combinations
Supervisory Interval:
70 minutes
Peak Field Strength:
Typical 36,000 uV/m at 3m
External Input Sampling Current:
20 uA
External Input:
Accepts N/C dry contact devices
Reed Switch Magnetic Sensitivity:
10 to 20 amp turns
Reed Sensitivity:
0.625 in. (1.59 cm) minimum gap, 0.85 in. (2.16 cm) typical
Magnet Dimensions:
1.3(L) x 0.435(W) x 0.312(H) inches (3.3 x 1.1 x 0.79 cm) typical
Magnet Type:
Rare earth
Sensor Dimensions:
2.59 x 1.03 x 0.49 inches (6.58 x 2.62 x 1.24 cm)
Weight:
1.1 ounces (31.2 g), including battery and magnet
Housing Material:
ABS plastic
Color:
White
Operating Temperature:
32° to 104° F (0° to 40° C)
Relative Humidity:
5 to 95 percent Non-Condensing
Battery:
Two Panasonic CR2032 or equivalent Lithium batteries (installed with pull tab)
Included Accessories:
Two Phillips flat-head screws